Get a quote
Free tool

Laser settings unit converter

Switch between the units laser software, machine manuals and online settings libraries use, without reaching for a calculator.

Resolution
Speed
Length
Image size

Engraves 0

Power

Laser settings come in a confusing mix of units. LightBurn shows speed in mm/s or mm/min, RDWorks in mm/s, older manuals in inches per minute; resolution may be DPI, line interval or lines per mm, and power a percentage of a tube's rated wattage. Type a value in any box below and the others update at once. Use it when copying settings from a forum, a supplier's material sheet or a machine with different software.

Resolution: DPI, line interval and lines per mm

DPI (dots per inch) and line interval are the same setting. Line interval in millimetres = 25.4 ÷ DPI, so 254 DPI is 0.1 mm and 500 DPI is about 0.05 mm. Lines per millimetre is DPI ÷ 25.4. The laser's spot size limits useful resolution: a CO2 laser with a 2 inch lens has a spot of about 0.1 to 0.15 mm, so going much finer than 0.08 mm on wood mostly adds time. Fibre lasers with a 0.03 mm spot can use much finer settings.

Speed and image size

1 mm/s is 60 mm/min or about 2.36 inches per minute. Diode laser settings are often posted in mm/min (for example 3,000 mm/min, which is 50 mm/s), CO2 settings in mm/s. For images, the printed size is the number of pixels divided by the DPI: a 1,200 pixel wide photo engraved at 300 DPI comes out about 102 mm wide. Engrave the same photo at 100 mm and 300 DPI and the software resamples it, so start with an image at least as large as the size times the DPI.

Power percentage

Power in software is a percentage of the laser's maximum. On a CO2 laser, that is of the tube's rated current, and most tubes last longer if you stay below about 80% (and below the current printed on the tube). A setting from a 100 W machine at 20% is roughly 20 W of output, which is about 33% on a 60 W machine, though tubes rarely deliver exactly their rated power. Always confirm with a test grid on a scrap of the same material.

Frequently asked questions

What DPI should I use for laser engraving?
254 to 318 DPI (0.08 to 0.1 mm line interval) suits most wood, acrylic and leather work on a CO2 laser. Use 400 to 600 DPI for fine detail on metal with a fibre laser.
How do I convert mm/min to mm/s?
Divide by 60. 6,000 mm/min is 100 mm/s, and 1,200 mm/min is 20 mm/s.
Can I copy settings from a different machine?
Use them as a starting point only. Tube age, lens, focus, air assist and the exact material change the result, so run a power and speed test grid before a real job.
Is lines per inch the same as DPI?
On a laser, yes in practice: the vertical DPI setting is the number of lines per inch. Horizontal resolution depends on the controller and is usually much finer.

More free tools

Get a free laser quote

Fill in the job sheet: what you want made or bought, how many, the material and where you are. Laser shops, dealers and suppliers who work in your area quote you directly. Free, no obligation.

Job sheetReference number assigned when sent

Items

LineItem, size or modelQtyMaterialRemove
L1
L2
Up to 12 lines. Not sure of the quantity? Leave it empty.
Options

Free and no obligation. By sending you agree that we may share your request with a suitable laser shop, dealer or supplier. See our privacy policy.

Get a free quote